I-INC CY199 DRIVER

Last edited by seanc; at Thanks Surej Attached Images. None of these methods worked. Hello, It sounds like you have a monitor with a common problem, we have repaired many Hanns-G monitors with this problem. If the serial number begins with an A:

Uploader: Doukinos
Date Added: 4 November 2013
File Size: 40.28 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 21448
Price: Free* [*Free Regsitration Required]

I-INC CYD LCD Monitor | eBay

Thanks for all the help Comments to this Manuals Your Name. When I go to the menu, set up menu, and down to input select it says “digital” next to it.

We do repairs on this model. You can find this repair guide at: If this equipment does cause harmful interference to radio or television reception, which can be. I have a monitor error, blue power light for 3 or 4 seconds, then it flashes in a pattern like morse code between blue and orange, then it repeats.

Apparently, this is a real problem with these monitors. Chapter 2 Display Controls By pressing ‘print’ button you will print only current page. Jun 03, Hanns.

  CONROE945G-DVI VGA DRIVER

As soon as you plug the power back into the monitor, release the buttons at the same time. Please enter a valid email address. Never be afraid to try something new. Find More Posts by hardwareguy.

I-Inc CY199D

You need to reset the monitor. Hi, I got a cy i-inc 19 ” screen that when connected shows only blinking blue and yellow led.

If the monitor has only 4 buttons plus the power button, there are only six possible combinations of two buttons, four of three buttons, and one of all four.

It needs the file and a programmer. Sounds like you may be SOL unless you can find the service manual.

Find More Posts by robm. The problem is caused by parts called capacitors overheating in the confined space of the monitor. I repair LCD Monitors.

monitor problem I-Inc CY – Tech Support Forum

These limits are designed to provide reasonable protection against harmful interference in a residential installation. I have changed all the capacitors but still no luck. Find More Posts by PlainBill. Refer to Chapter 3 for information on timing.

  BROTHER DCP 750CN DRIVER

Ii-inc have a monitor error, blue power light for 3 or 4 seconds, then it flashes in a pattern like.

Just be careful this eprom is very small and very difficult to remove without damaging the board, but it can be done. Now the bad news as the eeprom cy1199 used as a rom it is write protected on the board so the only way to program it is to remove it flash it with a valid program and then replace it easy if you are a surface mount expert. The time now is I’m not sure if the eeprom was fried because of this Aug 12, Hanns. Login to post Please use English characters only.

Please assign your manual to a product: